Subject:
|
Grumman F9F-5P Panther
|
Scale:
|
1/48
|
Manufacturer:
|
Revell/monogram
|
Price
|
US$ 40,00
|
Description
|
Injected plastic model with waterslide decals.
|
Comments
|
This is monogram´s Panther in recon version. The F9F-5P was built in small numbers, and used specially by the marines. The kit has raised panel lines, but excelent fit. Detail is also very good both in the cockpit and landing gear. There is almost no flash norejection pin marks. Here are some photos of the kit
|
Tuesday, July 15, 2014
Kit review vol.20 : Grumman F9F-5P Panther
Friday, July 11, 2014
Walkaround vol.12: M59 Armored Personnel Carrier
Location: South Military Command Museum, Porto Alegre, Brasil, 2012.
Comments: The M59 was a U.S. armored personnel carrier that entered service in spring of 1954 replacing the M75. It had three key advantages over the M75: it was amphibious, had a lower profile, and was considerably cheaper to produce. Approximately 6,300 were built before production ended in 1960. The M84 Mortar Carrier was a derivative of the M59. The M59 was replaced in service by the M113 family of vehicles. The vehicle has a welded steel hull ranging in thickness from 0.375 inches (0.95 cm) on the top to 1 inch (2.49 cm) thick on the belly with the median thickness being 0.625 inches (1.59 cm). Overall it is rather slab sided in appearance with a blunt nose. The vehicle has a single large compartment with the driver sitting at the front left, and the commander sitting to his right. The driver is provided with an M19 infra-red night vision periscope and several M17 periscope for driving in a buttoned up position. The commander has an M13 cupola, with a .50 calibre machine gun, for which 2,205 rounds are carried in the vehicle. Behind the commander and driver are two benches which run down the sides of the vehicle for the ten passengers. The benches can be folded up to make room for a single jeep. On either side of the passenger compartment are side sponsons which contain the vehicle's drive train. The drive train consists of twin GMC Model 302 6-cylinder inline petrol engine, each developing 146 hp at 3600 rpm. Both engines were directly connected to a Hydramatic model 301MG transmission (early models used 300MG) with four forward speeds and one reverse. Steering is through controlled differential via steering levers at the drivers station. The track is driven by a drive sprocket at the front. There are five road wheels per side, along with three return rollers. The vehicle uses torsion bar suspension and has shock absorbers on the first and last road wheel. On the road the vehicle has a top speed of about 32 miles per hour, considerably less than that of its M75 predecessor. 135 gallons (511 liters) of petrol could be carried giving it a road range of approximately 120 miles (150 km). The vehicle was designed to be amphibious, with rubber seals on all hatches and doors. A trim vane is provided. In the water it has a maximum speed of 4.3 miles per hour (6.9 km/h). The passengers are provided with a ramp at the rear of the vehicle, which has an escape door set into it. Hatches on the top of the vehicle are also provided. (reference: wikipedia).
Saturday, July 5, 2014
Military figures vol.4: German Navy Commander in WW2
Subject:
|
German Navy Commander WW2
|
Scale:
|
1/16
|
Manufacturer:
|
Unknown
|
Price
|
Unknown
|
Description
|
Resin casting figure in 6 parts plus 1 part in white metal and a resin display base.
|
Comments
|
This is the German Navy Commander i started building a few weeks ago. Fit was a problem solved by using two part epoxy putty. Painting was done with Tamiya acrylics with the airbrush, and detail were done with Vallejo acrylics. Everything was sealed with future and a coat of Humbrol Matt
varnish |
Walkaround vol.11: T17 Deerhound 6X6 Armored Recon Vehicle
Subject: T17 Deerhound 6X6 armored recon vehicle
Location: South Military Command Museum, Porto Alegre, Brasil, 2012.
Comments: The T17 6X6 armored recon vehicle, called Deerhound, was introduced in the American Army around 1942. Only about 250 units were built and were used only in the continental USA. Also in 1942, under the lend-lease agreement, some 20 vehicles were send to Brazil, were they served with the Military Police well into the 1970´s. Powered by two 110hp Hercules engines, the 18ton T17 could travel at 72Km/h. A crew of five managed the 37mm cannon and two .30cal machine guns.
Friday, July 4, 2014
Work in progress vol.13: German Navy Commander WW2: READY
Subject:
|
German Navy Commander WW2
|
Scale:
|
1/16
|
Manufacturer:
|
Unknown
|
Price
|
Unknown
|
Description
|
Resin casting figure in 6 parts plus 1 part in white metal and a resin display base.
|
Comments
| This was a present from an old friend. I got it without instructions and no box. Assembling was not a problem because there are so few parts. References for painting are easy to find, so i gave this kit a go ahead. Some plastic putty was necessary around the shoulders and two part epoxy putty was used around the legs where i found huge gaps between the parts. Now everything is under a coat of primer ready for the best part: painting! |
Subscribe to:
Posts (Atom)